Furnace & heating
Heat pumps
Ductless mini splits
Carrier
TraneSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateGoodman Heat Pump Service: The Woodland Hills Owner’s Guide
Goodman heat pump service in Woodland Hills typically runs $150 to $650 for most repairs, with the part and labor broken out separately so you see exactly what you’re paying for. We stock common Goodman heat pump parts on our trucks and can usually complete the repair the same day we diagnose it, depending on which component failed. Most Woodland Hills owners discover a problem when the system stops keeping up with a San Fernando Valley heat wave, or when the outdoor unit starts making a noise that wasn’t there last week.

Here’s the honest version: a Goodman heat pump is one of the most straightforward systems to service, because Goodman built its reputation on simple, reliable engineering with widely available parts. That’s good news for your wallet when something breaks. The less-good news is that heat pumps run nearly year-round in Woodland Hills, where our mild winters mean the system rarely gets a full off-season, so components wear faster than they would in, say, Minneapolis. We see this every week: a capacitor that lasted eight years in a cooler climate gives up after five here because the system cycles constantly.
If your Goodman unit is acting up, call us at (559) 245-8195. We’ll give you a straight diagnosis and a written price before any work starts.
Key Takeaways:
- Goodman heat pump repairs in Woodland Hills: $150 – $650, part and labor itemized.
- Most common failures: capacitors, contactors, defrost control boards, and reversing valves.
- We’re an independent service provider, not affiliated with Goodman, and we stock OEM and quality aftermarket parts.
- Every repair includes a written guarantee. If it fails within the coverage window, the second visit is free.
Which Goodman Models This Applies To
We service every major Goodman heat pump line, including the GSZ, GSZC, GSZH, and the newer GSZB and GSZM series, along with the higher-efficiency DSZC and VSZ models. If your unit was manufactured in the last 15 years or so, we have parts for it. Older units, especially the GSH series from the early 2000s, are harder to source for, but we can usually track down what’s needed or give you a straight answer about when replacement makes more sense.
Here’s the compatibility gotcha most homeowners don’t know: Goodman uses specific capacitor and contactor specs that vary by tonnage, not just by model family. A 2-ton GSZ14 takes a different capacitor than a 3-ton GSZ14, even though the units look nearly identical. This is a common source of failed DIY repairs. The best way to identify your exact unit is to check the data plate on the side of the outdoor cabinet. It lists the model number, serial number, and refrigerant type. Snap a photo of that plate and text it to us when you call. It saves a trip.
On the OEM-versus-aftermarket question: Goodman OEM parts carry a standard manufacturer warranty and are built to exact factory specs. Quality aftermarket equivalents from brands like Mars, Titan HD, or Packard often perform identically for 20 to 40 percent less. We stock both and will tell you plainly which one we’d put in our own unit. For safety-critical components like defrost boards and the reversing valve, we strongly recommend OEM. For capacitors and contactors, a quality aftermarket part is usually the smarter buy.
Halden Heating and Air Woodland Hills is an independently owned and operated service provider. We’re certified to service Goodman equipment, but we’re not affiliated with or endorsed by Goodman Manufacturing. We also carry parts for Carrier, Trane, and Lennox systems, so if you’ve got a mixed-brand setup, we can handle that too.
Styles & brands we work with





Signs Your Goodman Heat Pump Is Failing
A heat pump rarely dies without warning. Here’s what Woodland Hills homeowners notice first when a component starts going bad. If you’re seeing any of these, call (559) 245-8195 and we’ll diagnose it.
- Outdoor unit hums but the fan doesn’t spin. This is almost always a failed capacitor, which is the part that gives the fan and compressor motor their initial jolt to start. It’s the single most common Goodman heat pump part we replace in Woodland Hills, and the valley heat accelerates capacitor failure because the system cycles so often.
- Unit short-cycles, clicking on and off every few minutes. That clicking is usually a failing contactor, the electrical switch that tells the compressor when to run. A worn contactor will also sometimes buzz or chatter. Left alone, it can damage the compressor, which is a $1,800-plus part.
- System blows warm air in heating mode or cold air in cooling mode. This often points to a failing reversing valve, the component that flips the refrigerant flow depending on whether you want heat or cooling. It’s a bigger repair and a part we make sure to diagnose twice before recommending.
- Outdoor unit ices over in mild Woodland Hills weather. A frozen coil on a 60-degree night means the defrost control board or the defrost thermostat has failed. The board is what tells the system to briefly reverse and melt the ice. Without it, the unit turns into a block of ice and efficiency drops through the floor.
- You hear a rattling or grinding noise from the outdoor unit. That’s often a failing fan motor bearing or a compressor showing early signs of wear. Either way, don’t keep running it. The longer it runs with a bad bearing, the more likely the motor seizes and the repair bill doubles.
Replacement Cost & What’s Included
Goodman heat pump service pricing in Woodland Hills generally falls between $150 and $650, depending on which part failed. Here’s what that range looks like by component:
| Part | Typical Installed Cost | Repair Time |
|---|---|---|
| Capacitor | $150 – $250 | Same visit |
| Contactor | $150 – $250 | Same visit |
| Defrost control board | $250 – $450 | Same day, if stocked |
| Fan motor | $350 – $550 | Same day |
| Reversing valve | $550 – $650 | Same day, 3 – 4 hours |
Every price we quote includes the part, the labor, and a written guarantee on the repair. You’ll see the price before we pick up a tool, not after. If the same repair fails within the coverage window, the return visit is free. No arguing, no fine print. It’s covered automatically under our 365-Day Done Right Promise.

What drives the range is mostly the part itself. A capacitor is a $20 part on our shelf and 20 minutes of work. A reversing valve requires recovering the refrigerant, brazing the new valve in, pressure testing, and recharging the system. That’s a half-day job. We’ll always tell you which end of the range you’re looking at before we start.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Here’s the honest answer from Andre Fuller, who’s been doing this in the valley for close to two decades: some things you can check yourself, and one thing you absolutely should not touch.
What you can safely check: whether the thermostat is set correctly and the breaker hasn’t tripped, whether the air filter is clogged (a dirty filter is the most common cause of a frozen coil we see), and whether there’s debris or overgrown brush blocking airflow around the outdoor unit. Clear at least two feet around it. Any of these are free to fix yourself and might resolve the issue.
What you shouldn’t touch: anything involving the electrical components, refrigerant, or the reversing valve. A heat pump capacitor stores enough charge to hurt you even with the power off, and refrigerant handling requires EPA certification. We’ve seen more than one DIY capacitor swap in Woodland Hills end with a burned-out control board because the wrong spec part was installed. That $40 fix became a $400 repair.
If you’ve checked the simple stuff and the unit still isn’t running right, call us at (559) 245-8195. Straight price, straight answer, before we touch anything.
FAQs
A well-maintained Goodman heat pump in Woodland Hills typically lasts 12 to 15 years, which is a bit shorter than the 15-to-20-year lifespan you’d see in a milder climate. The reason is simple: our winters are warm enough that heat pumps here run almost year-round, which means more total cycles per year and faster wear on capacitors, contactors, and fan motors. Regular tune-ups in the $80 to $200 range can stretch that lifespan by catching small problems before they turn into compressor failures, which are the point where replacement starts making more financial sense.
Call (559) 245-8195 and we can tell you honestly whether your specific unit is worth repairing or if you’re better off putting that money toward a replacement.
For most Goodman heat pump components, replacement is the only practical option. Capacitors, contactors, defrost boards, and fan motors are sealed parts that aren’t designed to be opened up and fixed. The exception is the reversing valve, where the valve itself rarely fails; it’s usually the solenoid coil on top of it, which can be swapped separately. We’ll always check that first before recommending the full valve. If a part can be repaired rather than replaced, we’ll tell you, because a smaller bill is a bill more likely to get paid. For an exact diagnosis and quote, call (559) 245-8195.
Most common Goodman heat pump repairs, like a capacitor or contactor swap, take 20 to 45 minutes once we’re on site. A fan motor replacement takes 60 to 90 minutes. A reversing valve is the long one, typically 3 to 4 hours, because it involves recovering and recharging the system’s refrigerant. And since we stock common Goodman parts on our trucks, the majority of repairs are completed in one visit, not after a week of waiting for a part to ship. Book online and you’ll get a live arrival time so you know exactly when we’ll be there.
Yes. Our trucks carry the most commonly needed Goodman heat pump parts, including capacitors, contactors, defrost boards, fan motors, and reversing valve solenoids, so most repairs are completed same-day. For less common parts, we source from local supply houses in the San Fernando Valley and typically have what’s needed within 24 to 48 hours. If you want to confirm we have your specific part before scheduling, call (559) 245-8195 and have your model number ready. We’ll check while you’re on the phone.
Straight Answer on Your Goodman Heat Pump
If your Goodman heat pump is acting up, don’t run it into the ground hoping it sorts itself out. A part that’s failing today costs less to replace than the part it will take down with it tomorrow. Book online, get a live arrival time, and track your tech to the door. You’ll get a written price before any work begins, and every repair is covered by our written guarantee. Call (559) 245-8195 for a free estimate, or book online and we’ll see you same-day in most cases.
Written by Andre Fuller, Owner, Halden Heating and Air Woodland Hills at Halden Heating and Air Woodland Hills, serving Woodland Hills and nearby areas.